Browsing by Subject "Biochemical methane potential test"

Now showing 1 - 1 of 1

Development and evaluation of methods for assessing the efficiency of biogas plants
(2022) Hülsemann, Benedikt Werner; Müller, Joachim
Biogas is a renewable energy source with main advantages compared to other renewable energy sources. The advantages include the use of organic waste as a substrate, local power and heat production, rural job creation, the possibility of a flexible gas production and a product which can easily stored and transported in a gas grid or on the roof of a digester. However, the development of the biogas sector is highly dependent on the costs of producing gas, electricity and heat. The production costs are higher than the costs for other energy sources. Growth of the biogas sector is therefore only possible if there is political promotion for biogas as there was in Germany through the EEG. Nowadays, due to the reduction of bonus payments in the EEG 2017 and EEG 2021 in Germany as well as the lack of policy promotion in several other countries, lower production costs based on a higher efficiency are essential to help the biogas sector grow further. In order to achieve higher efficiency and to tap the full potential of biogas, the efficiency has to be determined, which is done in this thesis. The input methane potential is determined using 6 different methods. These methods are compared on the basis of an investigation of 33 German agricultural BPs as well as one German and one US BP using food waste as feedstock. The four methods based on the batch test show a high sensitivity. Unfortunately, they also show efficiencies greater than 100% for most BPs, clearly indicating an underestimation of the degradable potential. Only for the US BP can an efficiency less than 70% be reported. This result is probably based on the lack of heating system corresponding to the lack of promotion of heat recovery in the US. The CE according to the BMP method also reveals an average efficiency of 95% for the German BPs. The values of the two gross calorific value-based methods show efficiencies below 100%, but with low sensitivity. The results of these methods can be used to determine the further potential of a bioeconomic process and to compare the biogas process with other industrial processes. There are several impact factors that affect the accuracy of the efficiency measurements. The installed meters are not frequently calibrated at most BPs. Also, some meters are almost completely missing, as only few BPs in Germany have a gas flow meter. Thus, assumptions and calculations are required to determine the efficiency. In the developed method, the gas flow must be calculated from the amount of the power production, the calorific value, the gas quality, the CHP unit efficiency and the conversion loss at the transformer. The last two values must be assumed, even if the database is small. Another important parameter is the feeding mass. It is measured by the German BPs, but in some cases, the data quality is low. For example, different crops are mixed in the silos and measurement of each substrate is not possible. This leads to measurement errors shown by the organic dry matter mass balance, which has a residual value of up to 24%, while only 11% can be occur based on water incorporation into the ODM. Another factor having an impact is the sampling. The results of a monthly sampling throughout the year show a fluctuation in the DM/ODM values. To investigate the accuracy of the methods used to determine the SMP of the substrate, the biochemical methane potential test is examined in detail. The BMP consists of the used inoculum, the substrate, the digestion system and the calculation. The impact of the used inoculum and the digestion system is investigated by using different inocula in one digestion system as well as by using the same inoculum in multiple digestion systems. The inocula used in this thesis are well-known and have been used in interlaboratory tests for several years. Thus, outliners were excluded. A CV of 4.8% can be reported between the different inocula, which is lower than reported in most other publications before. The use of different digestion systems shows a higher CV of up to 12.8%. For the inoculum and the digestion system, the deviation varies strongly and no clear correlation can be identified. Therefore, a correction of this effect is not possible. The biological yield efficiency of 21 of the investigated BPs is in the range of 100 ± 12.8%. This reveals the need of stricter rules for the digestion system. All digestion systems used in this thesis are described in the German guideline VDI 4630. The calculations were also done according to the German guideline VDI 4630. An influence can be neglected. However, if the results of a measurement with already dried gas are compared with the results of a calculation according to VDI 4630, which is based on the measurement with wet gas, a discrepancy can be found. Although, the CV using only one digestion system and one inoculum is only 1-7%. A comparison of the efficiency of different BPs by using the same inoculum and digestion system is hence recommended.